Installing the Floor Mount

The Floor Mount requires to be bolted to the floor using four anchor bolts and nuts. It is the responsibility of the owning institution to provide the anchors to secure the kiosk.

For floor bolt holes and anchor details, see Bolt Holes.

To install the Floor Mount, perform the following steps:

1.Position the Floor Mount on the final installation location of the kiosk and mark the floor mounting holes on the floor.

2.Remove the Floor Mount.

3.Drill four mounting holes and install the four anchors.

a.Drill four 12 mm (0.50 in.) holes over the marked mounting hole locations.

b.Install four anchors into the drilled mounting holes. Make sure that the tip of the anchors does not exceed 38 mm (1.50 in.) from the floor surface.

4.Mount and secure the Metal Stand Legs on the anchors using four M12 nuts.